Rice Lake Benchmark LP Instalační manuál

104742Benchmark LPLow-Profile Bench ScaleInstallation ManualTM

6 Benchmark LP Manual3.3 Calibration ProcedureRefer to the indicator manual to determine correct calibration procedures.It is recommended that the sca

Service Information 74.0 Service Information4.1 Troubleshooting GuideSystem does not operate—no display• Power disconnected: Check and reconnect.• Ind

8 Benchmark LP Manual7. Position load cells with capacity label and load cell wires facing up, and loosely install the hex head cap screws (provided).

9Benchmark LP Limited WarrantyRice Lake Weighing Systems (RLWS) warrants that all RLWS equipment and systems properly installed by a Distributor or Or

ContentsContents ...

ii Benchmark LP Manual

Introduction 1About This ManualThis manual is intended for use by service technicians responsible for installing and servicing the Benchmark™ LP low-p

2 Benchmark LP Manual2.0 InstallationStandard installation of the Benchmark™ LP floor scale consists of the following steps:• Select a site• Check lev

Installation 32.3 Summing Board SecurityAfter an NTEP inspector has examined the unit, he/she will install security cables on the summing board cover.

4 Benchmark LP ManualCable RoutingThe cable must be routed to the indicator in a manner that will protect the cable from damage. When planning cable r

Adjustments and Calibration 53.0 Adjustments and Calibration3.1 Mechanical AdjustmentsTo accommodate minor floor unevenness, scale feet can be used to