Rice-lake DWM-IV Weighmeter Series 9 Setup Manual Uživatelský manuál stáhnout pdf (Strana 10)

Programming Recall Tare Values (Optional Series 9, if enabled)

(1) The optional Series 9 can maintain up to 10 predefined Tare

values.

(2) To program a tare value press [Shift] and then [8]. The display

will prompt [T 0-END] and then [t no. 1]

(3) Key in the desired tare register number (1-10) and press [Enter].

(4) The display will prompt [T XXX.XX]

(5) Enter the desired tare value.

(6) To Exit programming tare registers, enter ‘0’ at the tare register

prompt.

q Recalling a Tare Value (Optional Series 9, if enabled)

Enter the desired tare register (1-10) then press the

[Select/Enter] key. In sealed applications this function is only

available when the gross weight is at zero.

q Preset Output Settings (Optional Series 9, if enabled)

. Press [SHIFT] then press [ 9 ],

The display will prompt [S XXX.XX]. Key in the Start value for

Set point 1 and press [Enter],

The display will prompt [E XXX.XX]. Key in the End value for

Set point 1 and press [Enter]

Repeat the above sequence for Set point 2.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

Žádné komentáře

Rice-lake DWM-IV Weighmeter Series 9 Setup Manual Uživatelský manuál Strana 10